Unbrick Lucky- Bitaxe Miner

Unbrick Lucky- Bitaxe Miner. Flashed dead, no connection or Lucky Firmware 2.3.6 ? How to crack the miner!

There are many reasons to brick a miner. But how do you do it? Well, it’s not difficult, but follow the instructions as closely as possible!

Prerequisites

To connect the miner to the PC, you need a USB serial bridge adapter. If you don’t have one, you can get one from an electronics retailer. An adapter with TTL is usually used.

WARNING !

The actions described here can damage your device! All changes you make to your device are at your own risk. I accept no liability for damage to your hardware!

In the video we go through everything: disassembling the miner (if necessary), where the connections need to be soldered (if not present), the USB serial adapter and the correct connection.

Anschluss in detail

We only need three cables for the PC-Miner connection: TX, RX and GND.

Please note that the TX and RX connections are crossed:

🔹 RX from the USB adapter is connected to TX on the miner.
🔹 TX from the USB adapter is connected to RX on the miner.

Once everything is done, you can start flashing. You can find everything else in the following article:

Reflash Bitaxe- Lucky Miner

There is another video on the subject of flashing. This is about the extended version of flashing with ESP.

With this method, you can also overwrite the board version if it has been entered incorrectly – a problem that is particularly common with Lucky Miners. I have already had two Lucky Miners that could not be made to work with the WEB Flasher.

You can find out more about this in the next video!

Link to support / donation for the channel
PayPal Link
Bank transfer, Bitcoin and Lightning

Bitaxa #Mining #LuckyMiner #Flashen #ReFlashen #BM1366 #BM1368 #Ultra #Supra #LV06 #Bricked #Bricking #Unbrick